Ok so this whole project started three years ago with a Toyota and then decided I wanted a s10 instead so found a cab and frame that had already been back halfed because I don't have a bender yet, and I am redoing the fourlink that was set up on the chassis and the on the axle that I did but didn't like the way it turned out cause I rushed through it , and gonna paint it and put a exo on it. This is my first big build so if y'all see something that I need to fix or have some pointers tell me please.
Now for a parts list that the s10 will have
Gm 60 kingpin and 14 bolt ff
327 sbc (for now eventually 5.3 or 6.0)
Four link front and rear with 1.25 Heims
16" fox airs in the rear & 16" fox emulsion coilovers up front
Th350 & gm 205
42" tsl swampers on h1 wheels
Keep in mind I've been building this while in college hope Y'all like it
So far I got the motor trans and transfer case in and the front axle cleaned off and prepped and the truss made
What the s10 looks like before it's transformation
The coilovers And airs I got
[flash=200,200][/flash]
Axle prepped and truss made
Now for a parts list that the s10 will have
Gm 60 kingpin and 14 bolt ff
327 sbc (for now eventually 5.3 or 6.0)
Four link front and rear with 1.25 Heims
16" fox airs in the rear & 16" fox emulsion coilovers up front
Th350 & gm 205
42" tsl swampers on h1 wheels
Keep in mind I've been building this while in college hope Y'all like it
So far I got the motor trans and transfer case in and the front axle cleaned off and prepped and the truss made
What the s10 looks like before it's transformation
The coilovers And airs I got
[flash=200,200][/flash]Axle prepped and truss made
