I am looking to build another set of H1 wheels and I will start by saying I love H1s easy to break down, don't have to worry about cut beads and they don't leak the problem is I have built 3 sets of h1s and bent 2 sets the only centers that I have had luck with is the pressed 8 lug center but the new set is going to be for Rockwell so I can't find any pressed centers I bent 1/4 gusseted centers in one ride and have bent 3/8 flat centers. I am sure all these were made from some A-32 hot rolled steel I wonder if a set of 5/16 AR-400 gusseted centers would hold up better to the bending force that they see and hopefully save a little weight. From what I could find on the interwebs a-32 has tensile strength 58,000-89,000 psi and ar-400 tensile is 177,000-192,000 psi there any engineer type of people that could confirm my thinking on this????????