wheeler4x4samota
Well-Known Member
is it better to put a fuse before or after the switch????
-
Help Support Hardline Crawlers :
Stupid question
- Thread starter wheeler4x4samota
- Start date
WHITE TRASH1
fruit stripe
before of course. I always put the fuse as close to the battery as possible. The point of the fuse is to protect the rest of the system if there is a short in the power wire. kinda dumb to have the fuse on the other end of the power wire so if there is a short by the battery that part melts and starts a fire don't ya think? 
wheeler4x4samota
Well-Known Member
i figured but kinda had a brain fart so i needed to double check thanks man
WHITE TRASH1
fruit stripe
No worries, I do the same thing a lot more than it shows...
No worries, I do the same thing a lot more than it shows...
Dont we all :booo:
KarlVP
Love that TOYOTA
Your fuses should be at least 18 inches after the battery.
I got a kick ass fuse block from ED's electrical in Renton.
It give me 8 extra slots that I ran under the hood. I run my air compressor, rock lights, CB, and winch controls through it.
I got a kick ass fuse block from ED's electrical in Renton.
It give me 8 extra slots that I ran under the hood. I run my air compressor, rock lights, CB, and winch controls through it.
Cascade_Crawler
Well-Known Member
In need to pick one of these up. I assume you just have one big lead from the battery to power it?
WHITE TRASH1
fruit stripe
I run a hella fuseholder. Cheap deal but it works just fine for me to power all my aux stuff.
Now that I've found these ones I may swap over to one of them due to their seal.
http://www.hella.co.nz/?t=9&pcid=444
Now that I've found these ones I may swap over to one of them due to their seal.
http://www.hella.co.nz/?t=9&pcid=444
