toyota cab truck on tons

Just recently took my axles out from under my rig to start on a new project. Ive been rounding up other parts as they came available for the last year or so and im finally getting somewhere with it.
parts i have so far are
dana 60 5:13 with detroit
14 bolt 5:13 with detroit
th 400 and 205
Heres what i started with.

Picked it up the morning I left for king of the hammers so that was a busy day. If you didnt know already that was a blast :****:
Anyways came back home and started getting it set up in the shop.

That was about enough work for day one so the began

mocking up rear links

bring the front axle in for mock up

the chevy crate motor page in Jegs catalog stuck to my firewall

new parts

2001 lq4

picked up some half tread tsl and a groover


I took out the lugs for the tn cut with a wood chissel and a torch. The rest of this tire was all done with a 1/4" blade for all 6 hours it took. I had bigger blades ordered before the first tire was done :****:

Lookin good man glad ur doin sumthing with that cab

Thanks. How is yours coming along?

Slow money is tight gota wire it gear it drive shafts and exhaust

I know how that goes. I hope to have mine done by the end of June

Looking good, I had heard you got that cab. You planning on keeping this one together longer than the red one I hope.

I'll probably ride this one for a year or two then go up to Tennessee and hand over a trailer full of parts and a check for the next project. That is if I hit the lottery between now and then

Just a little update.

..

..

Not much progress latley but ive been rounding up parts and tools. Picked up some seats from wide open designs.

Model 32 manual bender and the notchmaster

This will be my first time bending tube.

I couldnt get the ride height/uptravel i wanted with the original frame there so I cut it off along with the exo from the A pillar forward.

DIY beadlocks