Cool go fast project

Fun project out of the old school Walker Evans book. Looks like I'm trading a job for some 14 inch FOA emulsion coil carriers, so I am going to Fab these Kings into quad bypass shocks. I need a 22r basher buggy bad, and now I have room to build it.... hehe

Dynamite Design said:

Fun project out of the old school Walker Evans book. Looks like I'm trading a job for some 14 inch FOA emulsion coil carriers, so I am going to Fab these Kings into quad bypass shocks. I need a 22r basher buggy bad, and now I have room to build it.... hehe

Click to expand...

will be interesting to see the tech behind building the bypass shocks yourself

Wish Robby Gordon would step in the garage for minute or two. I know they do something like this. Probably take out all the guess work punching holes....


So, I have the 8 inch shocks apart. Have to clean off all the loctite and dirt and whatever else kind of crap is in on the parts. Have to inspect all the seals, bearing rings, pistons, etc.

When I drill my holes for the 4 compression zones I know I am going to lose compression so when these shocks go back together, I will make sure I have a tough compression combination going back in.

The holes are going to act as a 4 zone progressive suspension setup. The faster I go? The better they should work....

Sweet, let F'k up some shocks

Interesting...

Where do you get the by pass tubes?

Thinking about using g a half moon piece of Dom. It will act more like a bypass chamber, rather than having check valves involved.

Been a month since the last update, how are the quad bypass shocks performing?