warn winch controller

Anyone ever replaced just the switch and not the whole unit? i got a bad "winch in" side to the old switch.

Yup. 3 way toggle from advanced/oriellys will do ya.

This is the one I used when I did the one for my 8274

http://www.oreillyauto.com/site/c/detail/CH00/55019/N0947.oap?ck=Search_N0947_1442061_-1&categoryRedirect=N0947&pt=N0947&ppt=C0335

http://www.waytekwire.com/products/1413/Toggle-Switches/&pageSize=36&Contact-Action=-On--Off--On-

If you want something that will last look at those and pick what works best for you.

Thxs fellas....warn told me I had to buy a complete replacement

That's about the only thing I was concerned about with the switch from vatozone/oriellys was the amp rating vs the old burnt up one I swapped it with, got the highest rated one I could find at the store. So far so good tho, its only been under a hard pull a couple times but its just flipping a solenoid anyways. It looks like the one in 1tonyjs remote might be rated for 240v, maybe check the home depot for something equivalent?

I wouldn't be concerned about the amps on the switch as they should be very low as it's just making a 12V power to the solenoid which is actually doing the work. The contacts are the issue with parts store stuff. In my experience anyway...

Just from being left out in the rig? I might pop mine back apart and hot glue it sealed if its a corrosion/moisture issue.

Make sure to get a momentary toggle switch, they are spring loaded back to the center / off position.