Fox Air Bump Stuck

87 Runner · May 14, 2015

I noticed 1 of my fox 2.0 bumps is stuck in the up position. Has anyone else had any experience with this or had the same problem?

WideOpenDesign · May 14, 2015

I bet your bolts are to tight on the can. They need to be just tight enough to keep the bump stop from falling out of the can. Loosen the bolts up and I bet you will be fine.

87 Runner · May 14, 2015

WideOpenDesign said:
I bet your bolts are to tight on the can. They need to be just tight enough to keep the bump stop from falling out of the can. Loosen the bolts up and I bet you will be fine.

Thanks for the help! Ill try that out.

al1tonyota · May 14, 2015

They will stick in if they don't have air in them also! Fwiw

muddinmetal · May 14, 2015

al1tonyota said:
They will stick in if they don't have air in them also! Fwiw

I laughed thinking the same thing :****:

Rockwells607 · May 14, 2015

A bent shaft will cause this as well

87 Runner · May 15, 2015

WideOpenDesign said:
I bet your bolts are to tight on the can. They need to be just tight enough to keep the bump stop from falling out of the can. Loosen the bolts up and I bet you will be fine.

I loosened up the bolts and the shaft extended back to normal. Thanks again.