Search results for query: *

Hope you find them...didnt see any keys when we were out sunday....I was the guy in the blue toyota

I talked to will for a bit watching some guys hammer down on a mud hole him and his group were cool.....I've managed so far without any major problems but I plan to put the yota down for a couple weekends and blow the dust off my bender

yea those guys in that truck were fine just a few bruises he was messing around on and rolled it a few times right after we lost sight of you guys

yesterday on the busywild we had a little carnage too

great now I got a bad name for being a hawaiian wheeler when i go to evans thanks to those ass hats

nada jsut bolted up some nice looking meats should start the EFI conversion pretty soon along with the front suspension bracket redo and the new tube work

wut up buddy

hey I think your trying to buy my junk lol

I run the 32/36 that it is true it is a PITA to keep in tune you are always keeping a small screw driver close by, 32/36 has the same cfm's as stock

I'll mark this date on my calender and give ya a hand

Dude!

I was hoping to join you guys tommorrow but I just got denied on sliding my birf back in today......so I have a bent housing again :mad: maybe next time

what trails are you running?

I tried my magnetic pencil tool and a telescopic with a bigger magnet and it woudl not work cause if it was free to move up then it wouldnt be in trouble. oh yea i squirted PB blaster in it not sure if thats ok for my bearings but i have changed my oil since then just be careful on forcing...

You can get to the oil pressure regualtor while its still on the motor take the cap off the oil pump then remove the spring its a pain in the butt to remove the piston looking thing. i used the ass end of a 1/4 deep socket it fit snug, with a slight tap tap tap. I was able to figure out what...

No snow lots of slop and very deep waters

video link Good times, next time busywild first thing. Sqaure front drive shaft on the next wheeling trip . :beer:

I was going up with a group tommorrow that just cancelled, I dont know any of you guys do you mind if I run with you? I am well built and equipped? 79 Toy 5" TG lift, 5.29, Locked F/R, 30 spline longs, armor everywhere, 36" tsl bias,tons on other poop, winch with tons of recovery gear and...

injectors

I am running 4" TG springs on 6" TG shackles with 35's I used to rub only when full stuffed with full lock on the trail Then I went nuts with the sledge and the sawzall.