Search results for query: *

Yup ditto Push the input shaft in and I bet it doesn't rub. So when its bolted to the tranny holds it back.

I seen a bad ass black lifted on yesterday on i -5 by the Tacoma mall. Looked like they were coming back from wheeling. It was the tallest one I have ever seen.

I just replace the whole backing plate assembly, unless your magnets and all look good?

Nice, glad your finally happy. Jus play in wit ya.:redneck:

Hurry up and put some 37" pit bulls on it and get bored with it and sell me the tires cheap! Anthony loves your old tires and wheels!

You can do the pan gasket with everything in. I just did one a few months ago. Gotta weasel it out though. And a + for the grey or black rtv, and yes the right stuff works good too But without the gasket I think I would try and make a new one to rtv in place.

front digging on a tractive surface trying to dragg the rear end. but do what you need to do, they are hand to have to hold while negotiating down hill with a clutch.

I blew up a front end doing this. Get a locker for the rear

Sure if you use them on a toy diff. I don't and I have set up a ton of them. Just wasn't sure cuz he said he bought the gears used. Carry on.

Are you just slipping that pinion head bearing off? Its supposed to be pressed on! And you may need the thick spacer between the bearing and pinion if there isn't one.

You can buy a motor for less then $100 on eBay. I had mine rebuilt years ago, that cost me $100.

Sean

The clutch slave will only push so far.

Not all throw out bearings are the same. There are like 4 diff. Ones over the years and half of them ha e diff. Heights. I had to take an arm off a later tranny for my early l series tranny for the later model throwout bearing to work, using a newer style throwout be cause the one that was in it...

Get rid of the crappy Toyota salt and put a Chevy one wire in it. You can make the stock brackets work.

Ive done a few, do it your self its easy.

Carl has always did me good.

Check out billavistas thread over on pirate about bolts nuts and washers. Very very informative.

I have a clapped out 22re on the engine stand with a bunch of head work that dynoed out at 140 h.p. on the dyno at max rpm. I just run stockers in both my rigs now. I usually just go find a good running one to throw in, usually 2 for the price of one new. I just bought a complete heard it run...

Hole drill works, just watch your fingers!