ok i have a morphed front 60. it started life as a 99 dodge 2500 unit bearing.
i retubed the long side and cut the short side to make it 80 size dodge or chevy....
the long side tube was machined for a seal area when installed. so the new 35 spline seals fit right in.
the short side however was never removed and is machined for a stock 31 spline seal. much smaller OD in the tube.
is there another seal i can use that will fit the bore and strech over the 35 spline seal area 1.565"?
i retubed the long side and cut the short side to make it 80 size dodge or chevy....
the long side tube was machined for a seal area when installed. so the new 35 spline seals fit right in.
the short side however was never removed and is machined for a stock 31 spline seal. much smaller OD in the tube.
is there another seal i can use that will fit the bore and strech over the 35 spline seal area 1.565"?