Well the front pump seal was leaking so i dove into it, The problem is the surface on the torque convertor is grooved to where it cant make a good seal. First thing i thought was a speedi sleeve, Are there any other reliable ways to get a good seal back? Replacing the convertor would hurt as its a pricey art carr unit. Any help would be appreciated and returned in the course of time...
-
Help Support Hardline Crawlers :
convertor to front pump seal surface
- Thread starter Bunk1
- Start date
Binder
Well-Known Member
If I understand what your saying that surface is very high tollerance. I would send it to a shop to be repared. They can cut it apart and reuse most of it.
Binder
Well-Known Member
Should be able to get it fixed and likely need to replace the bushing in the trans that it fits into.
