skipnrocks
Well-Known Member
So I'm nearing the final stages of my hybrid 9/60 rear axle. I am measuring for shafts and i got axle lengths of 37.5 and 38.75. My question is this seems long compared to what i see out there however I didn't cut my tubes as much as I see others do. Does this seem right? I got this length by inserting a 35 spline shaft from one of my spares into the housing marking where it hit the flange then adding 6 inches to account for the spindle and drive flange.
My follow up question is this. Would it be wise to just have 2-3 inches of extra spline on one side and then it it was a little long I can just trim it to fit? I can't see a huge downside to having a little extra spline
My follow up question is this. Would it be wise to just have 2-3 inches of extra spline on one side and then it it was a little long I can just trim it to fit? I can't see a huge downside to having a little extra spline