Any good way of getting the tip of an easy out, out of a stud? The stud broke about a quarter of the way down the hole in an exhaust manifold. Drilled the hole lubed it for a few days with liquid wrench, little pressure, little more pressure, heat on the manifold, little more pressure and plink.
I've tried tapping the edges of the tip to try and spin it back the other way, drill bit just slides off, center punch just gets the tip flattened.
What's next? Just **** it and JB weld a new stud in? :redneck: Or new manifold? How do the machine shops do it?
This is on an inline six if anyone cares.
Thanks
I've tried tapping the edges of the tip to try and spin it back the other way, drill bit just slides off, center punch just gets the tip flattened.
What's next? Just **** it and JB weld a new stud in? :redneck: Or new manifold? How do the machine shops do it?
This is on an inline six if anyone cares.
Thanks