CrustyJeep
Well-Known Member
I am considering turning a front 44 housing into a rear. My rear axle is only 55" WMS, so I think I could whack some of the long side off and use it to extend the short side. This would give me a rear 44 with 1/2" thick tube. I couldn't bend that if I had to
I'm thinking I could get a piece of tube to use as an internal "sleeve", bevel the hell out of the tube ends, and weld that biotch up with 100% penetration and get a good strong housing.
Any objections?
I'm thinking I could get a piece of tube to use as an internal "sleeve", bevel the hell out of the tube ends, and weld that biotch up with 100% penetration and get a good strong housing.
Any objections?