Recent content by Caver Dave

Actually... it's a SHE and will need the full monty

A club member needs some assistance installing a basic (old school) roll bar kit in a vintage Hurst Jeepster. Will need to be welded together and bolted down... Anyone in the Chattanooga, NW Georgia, or NE Alabama area?

Re: 2005 BMW 330i ZHP?

Link, heim & joint specs?

I've looked thru both threads (HL+NC4x4) pretty hard and can't find any info on your link specs... HBO?

Does anyone offer a PS Waggy width D44 truss? All I've been able to find were for DS Waggy or HP D44s. Wondering if Artecs (DS) tabs would still align with the top strap if "front" & "rear" plates were spun end to end? No issue making one, and may very well have to, but was hoping to use...

No sir... the difference in picture quality is pretty dramatic between the 2 and HD quality is the same as when connected directly to my dual-band HAM antenna. ;) There's no cable signal/feed (filtered at street?, because I still have Earthlink bandwidth piggy-backed over TWC wire). The cables...

Returned my boxes & told TWC to jam it 18 months ago... $1800 saved to date Tip... you'll get as many or more OTA-HD signals leaving your TVs hooked to the cable lines than 95% of the commercial antennas (getting 7-8 *more* than mohu shows). :****: I also have a $30 2m/70cm UHF-VHF (HAM)...

Keep in mind that around this time ('71), feds mandated the change from "gross HP" (no acc. @ flywheel) to "net HP" (realistic) ratings, along with a crap ton of other "fuel saving" BS.

Correct. While there aren't roving bands of FCC Nazi's ready to pounce on folks for unlicensed use... others will triangulate your location, drop the dime, and the FCC will show up PDQ. That does happen often and the penalties are huge (think 5-figure$) and/or time in the pokey. Spending a few...

Asking for knowledge... picking the collective brains Won't the frame-side lower link mounts exert a lot of leverage & torsional (twisting) force on the tube they're attached to? If so, is that tube heavier? Additional gusseting/tube planned?

@TacomaJD... How's that Pyle amp holding up? We put one in my brothers CJ a few weeks back, iPod/RCA cable feeding JVC 6x9 (rear) & 5.25" (front). Honestly, it doesn't have half the "thump" of my pawnshop Rockford Fosgate "Punch" 250 & narrowed (factory mutli-speaker) TJ soundbar... and he...

I've got an RCI cell (2161) and plumbed fuel hose "3 sides & down" with a spare fuel filter on the end. Local jobber was out of low pressure fuel hose, so got 15' FI-rated for a steal, which is enough to replumb the feedline stem to stern & the same pre-pump filter if needed in a pinch...

Saw this at my brothers place a few weeks back when he said that "everything (FL fixtures/AC/wall receptacles) would work, but not the exterior quartz worklights"... The issue there is usually an adapter from the 50A trailer-side plug to something other than a 50A receptacle. In his case, the...

For the record... 220VAC "Single Phase" *IS* 2 separate 110VAC circuits or "hot legs" ;) It's the same thing that feeds most houses... regardless if the house or trailer circuits use the combined 220VAC (Stove/Oven/HVAC) or the individual 110VAC legs (receptacles/lights) doesn't matter, it's...