Search results for query: *

95-97 Passenger side knuckle, need one to send to Sky to have machined, anyone got one?

Most everything on the bike has less than 15 hours. Was disassembled , powderer coated, all bearing, seals etc.. replaced. Total engine rebuild about 25 hours ago. It is set up for woods racing,suspension was re-valved for a 220lb "B" rider,oversized tank, skids everywhere, front and rear rotor...

I have 4 that were run at KOH last year and no where else, they look about new, I have one that is new and never run. 39x13.50x17......$1900 for all 5.

I've been slowly restoring my old ST90...I can rebuild this engine, but I figured maybe I'd swap a china 110 motor on it. The only ones I've found on ebay all have electric start and I'm really not sure if they are a direct swap to my frame. Anyone know or have a link to a good source for...

Any suggestions on who to buy a 3.1 lomax gear set from?

Looking for a jeep or buggy that is built and fairly nice. I'm willing to go to about 20k maybe a little more, but it's going to need to be V8,linked,tons or rocks,and can be driven at 40mph without worrying about killing myself or everyone else. Holla!

It's worth a ride to NC for this race, the track is awesome. There are fast spots and very technical spots, good pay out too. Here's a link with more info and a couple of pre-run vids from this past weekend of myself and JT. There will be classes from stock to full mod...

I have a hi9 with a broken R&P with a 35 spine spool that was geared 5.38. It comes with a BTF skid for the case that was over $200 when I bought it. It just needs to be regeared. The R&P can be bought from HI9. This was a dual thrust block model. $650 takes it all.

5 on 5.5 bolt pattern, 17x9, either 3.5 or 3.75 BS (honestly can't remember). One has a bent inner lip, but does hold air and rolls just fine, I was using it as a spare. The other 4 are fine, the lock rings are scared, but otherwise good to go. $500

3 of them 85% tread $900 deep treads, not shallow.

After reading lots of problems with vendors I'm sorta gun shy about ordering wheels. Anyone know a reliable source to order a set of Walker Evans from?

All I really need is the housing and knuckles...don't need a 3rd or shafts. Would love to find a 79 with no gusseting on it but will take any year, need it for rear steer axle in my wifes buggy. Have cash will travel...thanks.

Uwharrie National forest is located near Denton NC. The locals,myself included, around here go wheeling there all the time. Why haven't you heard of it? It's pretty easy, there are a couple of tough sections on a couple of trails, but for the most part your stocker can negotiate the place...