I screwed up

[wheeler4x4samota]

i used the winch to lift the front of my sammy to do the exhaust well when i got done i slaped myself because i forgot about the upper link clearence

in the mean time i dented the pipe in a little expecting it to run shitty due to more back pressure on passenger side bank

It ran fine thou i took some pics and wanted your opinions if this will hurt the way it runs

PLEASE NO BASHING IN THIS THREAD

I already know i messed up but im on a budget and it it will work ill run it

BTW This was my first time building an exhaust

 

[NotMatt]

I would run it.

[EDIT] at least temporarily until I found the motivation to fix it.

 

[bigiron]

JP.. it will run fine....I would fix it when you can but you will loose nothing from the damage.

 

[wheeler4x4samota]

thanks that is what i was hoping to hear

 

[darius]

I've seen worse, and know people that have been running it for years.

 

[boxboy]

Id run it but then again have you seen my jeep :redneck:

 

[Bodaciouscj7]

Its a non issue JP. You didnt crush it enough to really matter and there are some cars that had unbalanced exhaust factory. Take a look at a single exhaust 71 Cutlass with a 350.

 

[DHR Motorsports]

Put a cap on the exhaust and heat until bright red with a torch and put air pressure in exhaust with your compressor and work until it is pushed out.

Fixxered!!!

 

[boxboy]

Put a cap on the exhaust and heat until bright red with a torch and put air pressure in exhaust with your compressor and work until it is pushed out.

Fixxered!!!

Did you read his post? the upper link will just crush it again...