Damnyankee
Well-Known Member
Can anybody tell me the STOCK crank diameter for a 22r? (for the rod)
Need to check if the bearings are correct. i.e. +.025, .050.
I know the best way to check is with a plasti-guage BUT.
i think we spun a bearing, and possibly because the bearings were not right.
I'm going ot Mic the crank to check what the actual OD is, but what is the STOCK od. (don't know what machining was done prior.)
any help is appreciated.
Need to check if the bearings are correct. i.e. +.025, .050.
I know the best way to check is with a plasti-guage BUT.
i think we spun a bearing, and possibly because the bearings were not right.
I'm going ot Mic the crank to check what the actual OD is, but what is the STOCK od. (don't know what machining was done prior.)
any help is appreciated.
