Machining drw hubs to srw

Jeffy · Dec 19, 2016

Who is it that's on here that turns these hubs I've seen it before just can't find in the search box? Any help would be appreciated

Chaz · Dec 20, 2016

He-man machine in TN did mine . Traveler on here I think.

FlatlandFSJ · Dec 20, 2016

Jeffy said:
Who is it that's on here that turns these hubs I've seen it before just can't find in the search box? Any help would be appreciated

EddieHall in Pensacola does them, he's got a thread in the wanted section about it I think.

kmcminn · Dec 20, 2016

Robbiem said:
He-man machine in TN did mine . Traveler on here I think.

I called him yesterday. Seemed like he was done with offroad guys and parts.

TBItoy · Dec 20, 2016

kmcminn said:
I called him yesterday. Seemed like he was done with offroad guys and parts.

You just didn't sweet talk him enough

fordcontraption01 · Dec 20, 2016

Back when I talked with him about one of his carrier bearings he was a super cool guy willing to help :dblthumb:

biggin · Dec 20, 2016

Where are you located? I've done several sets. Just don't care to mess with shipping.

fabricator1 · Dec 20, 2016

I've done several sets also. If you're anywhere near Michigan

extremetownie · Dec 20, 2016

He-man is a great guy. Just burnt out. Think he is tyring something else.

kmcminn · Dec 20, 2016

extremetownie said:
He-man is a great guy. Just burnt out. Think he is tyring something else.

Thats what i got from our conversation. He was a great asset to the site to bad he left.

whiskeymakin · Dec 20, 2016

For the original question.....just snap a screen shot of the hub you want yours to look like, go to a local machine shop and have it done. Surely it's not that difficult

Woodlee · Dec 20, 2016

We can do them at Wide Open Design

Jeffy · Dec 21, 2016

Thanks Adam ! I'll pass that on to the guy I know needing them done. I had talked to ryan a couple months ago about an adapter, seemed like he was still doing a lot of fab work ! Great guy to deal with that's for sure.