sorry dude I was talking about my old 35s, not the 42s. I wont be selling those any time soon.![]()
sob.....I want bigger tires.
sorry dude I was talking about my old 35s, not the 42s. I wont be selling those any time soon.![]()
ANd if you do they are going back to me he he he:fawkdancesmiley:sorry dude I was talking about my old 35s, not the 42s. I wont be selling those any time soon.![]()
42s muahah.
Thanks Joe![]()
![]()
They are pretty east to rotate once they have been pulled off, but its tacked in place to match the uncut side.
basically, but a torch and a grinder is about $100, a lathe big enough to spin a housing is a little more money.
i was under the impression it had already been cut off the housing and just needed to get the piece out.
all the ones i have done i used a grinder to grind to the crack line as described above. unless the piece could be cut off with the C, then used a lathe for the C cause i had one available and it was faster then grinding. but all in all its the same process. gotta get to the crack line 360 deg then start working the C off.
i wish i could see the pics but photoshop is blocked here at work.
Where's the progress yo?
It will be a few days :awesomework:
its looks like you can throw down some good welds. you should finish welding up my bed for me.:awesomework:
its looks like you can throw down some good welds. you should finish welding up my bed for me.:awesomework:
Slacker, what, got more important thing's to do?
funny cause they look like **** compared to the inside ones that I was welding all out of position for :redneck:
what do you need done? i can weld pretty well if i do say so myself
would this be your 60 jonathan http://www.nw-wheelers.com/shopcam/